Hi Tom,
using previous version (4.30) - I had a setup that
a. Button M3 Set 1 (one) bit 158
and
b. Button M5 do Set 0 (zero) bit 158.
same settings apply in M3/M5 program mode. ( I try also with no actions in Program mode )
using those settings in 4.31k .
I had this message :
Set 1 expected 0 ,program aborted.
Sure, I did not remember all message :) , then system put all axis in halt mode.
I give-up at settings and implemented one in Thread 1, this work fine since then.
I send this e-mail just to clear the issue.
I also send you some pictures, proving that old stuff got big achievements
when used properly. :D
All of you :
Marry Christmas,
Vio
